The manual of free energy devices and systems Date: 06 May 2011, 18:29
|
The subject of free energy and perpetual motion has received much undue criticism and misrepresentation over the past years. If we consider the entire picture, all motion is perpetual! Motion and energy may disperse or transform, but will always remain in a perpetually energized state within the complete system. Consider the "free energy" hydro-electric plants. Water from a lake powers generators and flows on down the river. The lake though is constantly replenished by springs, run-off, etc. Essentially, the sun is responsible for keeping this system "perpetual." The sun may burn out but the total energy-mass remains constant within the cycling universal system. Vacuum is charge flux without mass, containing a high electrical potential of approximately 200,000,000 volts relative to pure zero charge. Within an ordinary electrical circuit, the ground has a valued zero charge with respect to something else with the same absolute potential, but actually has a non-zero absolute potential relative to the vacuum. Present theory explains that we can create a difference in potential "within" the parts of a system only by displaying electro charge mass. By pumping the electrical mass between potentials we can only get back the work that we put into the system. Orthodox science has confused charge and charged mass, ignoring scalar electrostatic waves. (Note that "ignor-ance" is the operative word here). Recalling that the vacuum's charge flux is massless, any charge flow would be scalar and normally incapable of doing any work (change of momentum - requires mass movement, -F = ma + v(dm/dt). By electromagnetically oscillating the true ground vacuum potential, we create an added resonating electrical potential difference between that part of the circuit and the normal rate ground voltage of the rest of the system. Maintaining the correct harmonic vacuum oscillation will produce the excess potential needed during the negative half-cycle to sustain the work load. As can be seen, we have not produced energy from anywhere, but merely diverted and juggled the inate high potential of the energized vacuum! By AR&D, P.O. B. 323, C.D.A., ID, 83814 (1984) THIS MANUAL FULLY DESCRIBES THE VARIOUS PIONEERING PROTOTYPE "FREE ENERGY" POWER PROJECTS BEING DEVELOPED AND EVOLVED IN THIS MAJOR NEW AREA OF APPLIED PHYSICS. THE MANUAL IS DIVIDED INTO FOURTEEN TYPES OF SPECIFIC PROJECTS IN BOTH ROTATING AND SOLID STATE UNITS, AND HYBRIDS, WITH SOME TYPES SUBDIVIDED INTO OTHER SUBCLASSES, AS NOTED IN THE ENCLOSED TABLE OF CONTENT. CONTRARY TO THE OUTMODED OPINION OF MANY WELL ESTABLISHED PHYSICISTS, THESE VARIOUS UNITS AND SYSTEMS ARE HERE AND NOW EVENTS WHICH WILL CONTINUE TO BE IMPROVED UPON UNTIL A "NEW WAVE" OF APPLIED ENERGY PHYSICS IS IN PLACE, AND THE OLD BELIEFS AND VIEWS FALL BY THE WAYSIDE! Copyright © 1986 General Content & Format, other Copyrights, as noted ISBN 0-932298-59-5 1st Printing 1986 ELECTRODYNE CORPORATION Clearwater, FL, 33516 2nd Printing 1987 3rd Printing 1991 - Published by CADAKE INDUSTRIES & TRI-STATE PRESS P.O. Box 1866 Clayton, Georgia 30525 # Paperback # Publisher: Cadake Industries (1987) # ASIN: B000SQI5HQ PassWord: www.freebookspot.com
|
DISCLAIMER:
This site does not store The manual of free energy devices and systems on its server. We only index and link to The manual of free energy devices and systems provided by other sites. Please contact the content providers to delete The manual of free energy devices and systems if any and email us, we'll remove relevant links or contents immediately.
|
|
|